Wireless

Hi all,  Assume having a foreign WLC in a centralized datacenter and another centralized Guest Anchor WLC in a DMZ for providing guest access. Flexconnect AP's from different remote offices are using the foreign and guest anchor WLCs providing wirele...

Dear Team, We have WLC 2504  , having ZA as country configured , and having all of the APs are with model AIR-LAP1142N-E-K9. All the six AP s are working fine. But we need to add one more AP, which is   AIR-LAP1142N-N-K9 . Could you please let me kn...

I am wondering if a single adder licence can only be applied to one controller or if it can be used for both a primary and secondary controller. This is under the right to use agreement. 

Hello, Hoping that someone already encountered this issue and have your guidance. We recently upgraded our Cisco 5508 WLC. But after upgrade we are able to reach the management address for a few minutes but wlc went down after. We are able to get co...

Dear experts, Can anyone tell me which cisco product or solution support EAP method such as SIM or AKA except for Prime Access Register? Currently my customer have ISE and WLC and seems these doesnt work... Regards, Jun

In below connectivity scenario how I can provide IP addresses to my wifi clients. I'm configuring static IP config to my AP. Wireless Clients > Access Points > Access switch  Access switch > Distribution switch  (Layer 2 trunk) Distribution switch >...

Hello,  I currently have multiple 1242 AP, I have to log into each individually to manage. I recently setup (12) 1852 AP, and they all connect to the primary controller 1852AP. 1852 is setup to use wpa2, can devices seamlessly move from the 1242ap to...

Hi everyone, We have a 5508 WLC with version code 7.6.130.0. Everything was working fine until last friday, clients that were not on the local mac addres data base and should not have access to the wlan were login in, so everyone was able to log in ...

Hi Community. Until now we're using the Site Survey Kit from Caster Tray http://www.castertray.com/surveyor.html. That works great with the old Cisco AP's that uses POE. But the newer AP's uses POE+ as an example the Cisco 3802. How you guys are doi...

Hello Guys. Please, I need your help to find out the right command to list the data rates negotiated by all the clients connected to the APs. I have tested successfully: grep include Rates "show client detail c4:8e:8f:fc:20:ab" But I am looking a CL...

Hi, We bought a Cisco 1852i AP (AIR-AP1852I-E-K9) but it was shipped with the Lightweight mode image, can someone supply us with the conversion to Mobility Exporess image that can be found here: https://software.cisco.com/download/release.html?mdfid...