cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
10670
Views
20
Helpful
6
Replies

How to diable network 802.11 a/b from WLC GUI

Ibrahim Jamil
Level 6
Level 6

Hello Guys

 

How to diable network 802.11 a/b from WLC ,to meet US regulatory from  both GUI and CLI

 

 

Thanks

 

1 Accepted Solution

Accepted Solutions

Ah okay….You need to disable both radios first:

config 802.11a disable network
config 802.11b disable network

Make your changes then enable the radios.
-Scott
*** Please rate helpful posts ***

View solution in original post

6 Replies 6

Scott Fella
Hall of Fame
Hall of Fame
You only can disable ‘b’ not ‘a’. You can disable ‘b’ by disabling data rates from 1-11mbps. You can prevent ‘b’ clients from the radio policy in the WLAN.
-Scott
*** Please rate helpful posts ***

hello bro

 

I am trying to change the country from KW to US ,coz our AP didnt join , after the change of country from KW to US , popup msg says : network 8.2.11a , network 802.11b must be disabled prior to change to US country  , now all my radio interfaces are down

 

exact model of AP is : AIR-CAP3502I-A-K9

 

Thanks bro

Ah okay….You need to disable both radios first:

config 802.11a disable network
config 802.11b disable network

Make your changes then enable the radios.
-Scott
*** Please rate helpful posts ***

Thanks bro

Is it possible to perform the Disable network on only a single AP group?  We need to adjust data rates for a single site without taking done all networks that terminate on the WLC

Review Cisco Networking for a $25 gift card