I have an AP 1100 with IOS 12.2(13)JA3 with an internal g radio. When I do a "sh int dot11radio0", it always shows that the output queueing is FIFO.
I configured one of my data VLANs with a service-policy map to set all the data on that VLAN to cos 1, but I still see only FIFI queueing.
How do you enable the 8 queues?
Also, once the queues are enabled, is there any command to see the traffic in each queue so I can be sure that my traffic is being queued correctly?
Thanks
