Wireless

We have a (brand new) WiSM blade installed in a 6509. The configuration looks ok, but when we try to register (join?) an AP with the controler the process fails. The controler shows the AP in the status display but the AP reboots, claiming that no ...

As the title suggests, I can only get one wireless client to connect successfully to the AP when I am using WPA-PSK. The Client Computers (winxp sp2) attempt to connect, I can see the client attempts to connect to the AP, but they never get an IP add...

I'm trying to deploy an AP-1220B that's had issues for a long time; I seem to have isolated the cause to CRC errors on the Ethernet interface.I've attached the config of the WAP; can anyone point out any anomalies that need to be corrected? I've done...

Hi,I'm setting up my ACS server using MAC address to authenticate. I've over 1500 MAC addresses thus is there any way to mass import the MAC addresses into the ACS?With regards

could please anyone suggest me how to how to configure ip adresses for wlanwith 5 users.

I have 7920s using open authentication with WEP128 cipher. I have two 1300 root AP's (with client support) and three non-root AP's (also client support) in the same lab area. The root AP's and non-Root AP's associate and link to each other no problem...

I'm using two wgb350's in a bridge spanning about 1 mile. The antenna check shows 98% link and netstumbler on one end looking at the root-bridge shows 32-36db SNR. The link runs fine for about 98% of the time. However for about 2hrs in the afternoo...

Do anyone know of any script that tweak the registry to disable the wireless NIC when both the wired and wireless NIC is detected. In situation where both the wired and wireless NIC is enabled, we want a script that alter the registry key in XP to di...

Hi Guys,There are two antennas on my Cisco 1242 AP. How can I verify which antenna is active? The left one, or the right one?Thanks,yytellmey

For cisco aironet which standard should be used in India FCC or singapore standard ?

I migrated an wireless network with autonomous ap 1231 access-points to a LWAPP solution with 4402 controllers.After this migration a ap 1231 workgroup bridge don't work. Is the IOS workgroup bridge compatible with a controller 4402 LWAPP solution?Is...

We are setting our Lightweight APs with Primary, Seconday and Tertiary controllers in order to have failover. Since we are doing this, can I disable "AP fallback"? If we were to lose all controllers, Primary, Seconday and Tertiary , where would the A...

I have an issue here. I have roam from Level 1 to Level 3. The wireless client (running MS zero configuration) is still keep associating to AP at level 1. This is despite the fact the AP at level 3 has stronger signal strength. Pls advise if this is ...

I came across the 3Com NJ220 switch-in-a-wall-jack that claimed it could be powered by "some Cisco proprietary Power over Ethernet schemes". Does anyone know what these schemes are? Are all the older Aironet products (say AIR-PWRINJ2 and AIR-PWRINJ3)...