cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
831
Views
0
Helpful
2
Replies

how to load ap's on dna spaces ?

venkat_n7
Beginner
Beginner

I have loaded maps on dna space center and ap's aswell, but not sure how to add those ap's over the map, any idea how i can add access points on dna space maps ?

 

 

Please rate comments and support
with regards,
Venkat
2 Replies 2

Grendizer
Cisco Employee
Cisco Employee

You need to have the APs on the maps before you upload them to DNAS then they will show up, there is no manual process for this step. Either this can be by Prime and you need to reupload those maps again with any changes like adding APs, removing APs, changing the location of the APs, in any situation you have to reupload the map again, or you can use DNAC to automate this process.

don.click1
Enthusiast
Enthusiast

What about updating coverage zones, inclusion areas, walls, doors, etc? is it the same - edit them in Prime then export/import? is there no MAP EDITOR in Spaces?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: