how to pair aironet 2600 series together?

[yhyhyh861]

Hi guys,

I am a beginner for network setup. I want to pair up all my aironet 2600 series together with connect a lan camera with each of the aironet.

I want to set an access point as my parent then other ap connect to that access point. How do i set the parent and child and the way to link up all ap togethet?

Regards 

isaac

[yhyhyh861]

Additional info. I didn't use wireless la  controller.

[Abhishek Abhishek]

Deploying the Access Point on the Wireless Network

After you have mounted the access point, follow these steps to deploy it on the wireless network:

Step 1 Connect and power up the access point.

Step 2 Observe the access point LED (for LED descriptions, see “Checking the Access Point LED” section ).

a. When you power up the access point, it begins a power-up sequence that you can verify by observing the access point LED. If the power-up sequence is successful, the discovery and join process begins. During this process, the LED blinks sequentially green, red, and off. When the access point has joined a controller, the LED is green if no clients are associated or blue if one or more clients are associated.

b. If the LED is not on, the access point is most likely not receiving power.

c. If the LED blinks sequentially for more than 5 minutes, the access point is unable to find its primary, secondary, and tertiary Cisco wireless LAN controller. Check the connection between the access point and the Cisco wireless LAN controller, and be sure the access point and the Cisco wireless LAN controller are either on the same subnet or that the access point has a route back to its primary, secondary, and tertiary Cisco wireless LAN controller. Also, if the access point is not on the same subnet as the Cisco wireless LAN controller, be sure that there is a properly configured DHCP server on the same subnet as the access point. See the “Configuring DHCP Option 43 and DHCP Option 60” section for additional information.

Step 3 Reconfigure the Cisco wireless LAN controller so that it is not the Master.

Note A Master Cisco wireless LAN controller should be used only for configuring access points and not in a working network.

[Leo Laohoo]

If you're talking about a point-to-point wireless bridge, then go HERE.

[Rasika Nayanajith]

if you want to connect a wired device behind AP & connect it to a Root AP, then you can configure it as WGB as well. If that is something you looking for see below post as well

http://mrncciew.com/2013/06/13/wgb-with-psk/

HTH

Rasika

**** Pls rate all useful responses ****

[sbhadrav@cisco.com]

The Cisco Video Surveillance IP Camera provides configuration windows that you use to configure and manage the IP camera. This chapter explains how to access the configuration windows, describes each window, and provides detailed information about the options that are available in each window.

When configuring the IP camera, be aware of these guidelines:

•You must install and set up the Cisco Video Surveillance IP camera as described  2, "Getting Started," before you can access the configuration menus.

•You must be an IP camera administrator or an IP camera user with administrator privileges to access the configuration windows.

•For security, the configuration windows time out after 2 minutes of no activity. If a time out occurs, a pop-up window prompts you to log back in by entering your user name and password when you next press a key or click an item. When you log back in, the configuration window that you were displaying remains on your screen, but all settings revert to their last saved values.
please find the below link for more info;-
https://www.cisco.com/c/en/us/td/docs/security/physical_security/video_surveillance/ip_camera/2600/user_guide/2600ug/ipcaweb.html