How to tell Access Control list is used by which ssid

[mahesh18]

Hi Everyone,

One of our customer WLC is configured with 2 ACLs.

This WLC has 3 SSIDs.

How can i tell which ssid used which acl in gui?

Regards

Mahesh

[ali aqrabawi · Accepted solution]

you can go to WLAN tab --> click on the SSID --> advance tab --> and see if there is any override ACL 

also note that the ACL can be applied on the interfaces , go to controller tab -->interface -->click on the interface and check if any ACL is configured on the interface , 

[mahesh18]

I do see the ACL applied under

click on the SSID --> advance tab --> and see if there is any override ACL - See more at: https://supportforums.cisco.com/discussion/12545521/how-tell-access-contril-list-used-which-ssid#sthash.q7Yz5SlL.dpuf.

But i do not see any ACL applied to the interfaces.

Does it make any difference applying ACL to interface as compared to applying on SSID?

Regards

MAhesh

[ali aqrabawi · Accepted solution]

no difference in the way it work , it just that one ACL will override the other , 

WLAN ACL take precedence over the interface ACL , (it actually override the interface ACL)

[mahesh18]

Many thanks Ali

Regards

MAhesh