I cant connect AP2702I in Flexconnect mode

[dani210867]

Hi, I have several ap2702i in FlexConnect mode without any problems, but 1 in particular, connected to a WS-C4506E only works in local mode. When I set the port to trunk (from access), the AP starts to reset without stopping. Some will know why this happens?.

Best regards.

[ali aqrabawi]

i'm just guessing :

if you set allowed vlans on the trunk port (not allowing all vlans) , does this issue happen ? 

also have you configured the correct native vlan in that trunk port ? so the AP can obtain the right ip address ? 

[dani210867]

The only diference with others AP's (who are working well in flexconnect) is the Catalyst 4506E.

Port configuration for Local Mode (AP works well)

interface GigabitEthernet2/47
 switchport access vlan 3
 switchport mode access

Port configuration for Flexconnect Mode (AP don't work)

interface GigabitEthernet2/47
 switchport trunk native vlan 3
 switchport trunk allowed vlan 1,3,8-10
 switchport mode trunk

Regards

[ali aqrabawi]

when the port is configured as trunk are you able to ping the WLC from the AP ? 

[dani210867]

No, AP not responding till the port is configured as an access again.