Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have several ap2702i in FlexConnect mode without any problems, but 1 in particular, connected to a WS-C4506E only works in local mode. When I set the port to trunk (from access), the AP starts to reset without stopping. Some will know why this ...
Hi ,we implemented CWA for wireless guest access using ISE. However we have an issue, the redirect URL is a name, not an IP address, and the guest dhcp scope use public DNS servers, so CWA doesn't work unless we set the company DNS servers.
Is there ...
Hi, I am adding a second MPLS link between HQ and a branch office. Could anyone explain me, how do I set up my QoS for voice and video pass through both links?Best regards.
Hi, I have a site connected with 2 mpls links to a headquarter. Boths mpls links are active and we need use them to pass VCoIP.We use Cisco SX20 and MCU Codian 4501 and VCS Control.My question is how should do we create pipes and links to reflect the...
Hi, can you help me with any article to teach me to configure a vpn tunnel over the Internet as a backup link.Currently I have a mpls link as a primary running eigrp protocol. Thank you very much
The only diference with others AP's (who are working well in flexconnect) is the Catalyst 4506E.
Port configuration for Local Mode (AP works well)
interface GigabitEthernet2/47 switchport access vlan 3 switchport mode access
Port configuration for Fl...