Increasing CIsco 1200 AP Throughput

[nixtan]

Hi,

I'm having a problem achieving good performance on a Cisco 1200 AP [802.11b] which supports about 15 clients. It's been configured to allow only 11MB & 5.5MB access with static WEP & w/o SSID broadcast. But somehow the performance is way below satisfactory & it took about half an hour just to copy a 500MB file between 2 computers. Is there anything that i may had missed out during the configuration? Please advice, Thanks!

[umedryk]

This could be the problem with the other devices in the network. Not necessary that the issue is with 1200 AP

[thisisshanky]

Check the 1200 error counters (under radio interface Detailed stats) and see if CRC errors are increasing in huge amounts. If yes, this could be a cause for the slow down. You might be experiencing interference. Did you do a site survey (including scanning the surrounding for interference) before installing the AP.