Instalation Aironet 350 Workgroup Bridge

[fabio.cunha]

I have tried to configure an ip address ina A WGB-350, but the IPSU returns this message (THE DEVICE DOES NOT ANSWER). I try with a cross cable in a non-network computer and with a direct cable in a network computer, but the device doesn´t answered.

Can you help me ? What is happenned?

What is the IP and subnet default?

[lisa.hall]

If you inadvertently modified the IP address from its default value, you’ll probably have to console connect to it and use command line to see it so you can browse to it and modify it.

[gboggia]

I had the same problem. The best solution is to reset to default your workgroup bridge pressing the "configuration reset button" (see the figure on the "configuration hardware guide" at page 1-2). Thus, you could connect to WGB with a cross cable and web browser (using the default IP address of this device: 192.168.200.1).

I hope it is a good solution for you.