ISE Support IPV6 Dynamic ACLs

[gavin-taylor99]

Does ISE support IPv6 in its dynamic ACLs? We are a dual stack IPv6 site at present. We could leave the guest LAN on an IPv4 only site for the moment, but we intend to go forward and support IPv6 fully. If we wanted to apply DACLs to a port that had a Dual Stack arrangement, is that possible from ISE?

[Guillaume BARBEROT]

ipv6 support for ise is not implemented yet (version 1.1.3 or 1.1.4)

i thought it will arrive in version 1.2

but as i am looking to improvements in version 1.2 Q&A i cannot see anything about ipv6

http://www.cisco.com/en/US/prod/collateral/vpndevc/ps5712/ps11637/ps11195/qa_c67-658591.html

our customer has blocked ipv6 on wifi as we cannot put dynamically one ipv4 and ipv6 ACLs at the same time

if someone as some "official news" about ipv6 ... would appreciate

rgds,

guillaume

[Ravi Singh]

The level of support for IPv6 in Cisco ISE is only  as it relates to the node being addressed on an IPv6 network (for  example, IPv6 stateless auto-configuration and DHPv6). However, none of  the Cisco ISE, Release 1.0.4, protocol stacks (such as runtime or mgmt)  supports IPv6. Moreover IPV6 is not supported by ISE 1.2