Lighweight AP 3600i

[FRasuli01]

Set a Lightweight IOS on Cisco AP, then type copy run-config startup-config and then type reload command.  And now can not ping the AP and Can not telnet it.... What's problem.... What to do?

[Leo Laohoo · Accepted solution]

Set a Lightweight IOS on Cisco AP, then type copy run-config startup-config 

Controller-based IOS will NOT save configurations.  All configuration is done on the WLC.   So when you set an IP address and you reboot the AP, the AP will discard the settings and go back to default configuration (no IP address).

Exactly what are you trying to do?

[FRasuli01]

Hi Leo, 

Thank You for answer.

I'm trying to configure AP with Lightweight IOS and WCL. Need some instructions. 

[Leo Laohoo]

I'm trying to configure AP with Lightweight IOS and WCL. 

Read this:  DHCP OPTION 43 for Lightweight Cisco Aironet Access Points Configuration Example

[FRasuli01]

Thank You!

[FRasuli01]

Look , right now can not enter to AP by console, how i can configure any  sets?