Local Mac Filtering Security WLC

[Haidar2205]

Is this because the difference about WPA2-PSK Security and Mac Filtering Security ? it can say that its the weakness of Mac Filtering Security, this is below the scenario test

I have tested that with this scenario my mobile phone connect to SSID A  in Access Point 1 (AP-1) 

which is using Local Mac filtering Security then I move to somewhere that has another Access Point 2 (AP-2) but  I see in monitor client my device (mac address ) still conncet in SSID A in Access Point (AP-1) not move in AP 2  also it can see in LED indicator is not turning into blue color but still in green color (it is in AP-2802)

then in another scenario, my mobile phone connect to SSID B  in Access Point 1 (AP-1) 

which is using WPA2 PSK security then I move to somewhere that has another Access Point 2 (AP-2)

I see in monitor client my device (mac address ) conncet to SSID B in Access Point (AP-2) it is moving to AP which is near with it

The security configuration in each is also enabled Fast Transition

[craigshawm6]

The client dictates which AP it will connect to. Sometimes it's hard to force the client over to a different AP when it can still see the first AP. 

[Haidar2205]

yeah but with this mac filtering security make signal indicator looks weak then effect to data rate or connection, but if I use WPA2-PSK it could good and quick transition to the AP that near with the client, it can say automatically connect in,

the real question how do I make SSID with local mac filtering could do fast transition in different AP that near with him ?

Thank you for your response