Mib for reading/setting RF channel on standalone Access Points

[r.aurlund]

Hei Everybody.   Does anybody know if there is a SNMP mib sfor reading/setting RF channel and other RF-parameters on 1131AG standalone Accesspoints. In my network we are  using the "least congested frequency"  choice for Channel selection and wants to se what the result for this is.

Regards, Roy

[Scott Fella · Accepted solution]

"Least Congested Frequency" does not work.... either set your AP's to a specific channel or only highlight channels 1, 6, or 11.  You can use a mib browser to seethe mib listing... this link migh help... son't know if its different from the 1131AG:

http://www.oidview.com/mibs/9/CISCO-DOT11-IF-MIB.html

[r.aurlund]

Thanks a lot, just what i was looking for.

[Scott Fella]

Just remenber.... don't use "least congested" setting:)

[r.aurlund]

Hi.

Yes, I know I  have to highlite 1,6 & 11 in order to useleast congested channel in order to keep interference down.

Thanks for reminding me anyhow.

Roy