Missing information on Sup 7L-E 10GE (show command)

Lance Wendel · ‎10-10-2012

Hello all,

My customer has upgrade his 4506 from 6L-E to 7L-E 10GE

Ever since then if he run the command

show dot1x interface gigabitEthernet x/x details

some information are not been displayed (below are missing information)

PortControl =

ControlDirection =

HostMode =

Is this intensional or do I need to kick this to TAC?

or has someone come accross this before?

thanks in advance

Lancellot

Lance Wendel · ‎10-11-2012

hi all,

just a bit more info, based on cisco command reference

if you do

Switch# show dot1x interface fastethernet6/1

Dot1x Info for FastEthernet6/1

-----------------------------------

PAE                       = AUTHENTICATOR

PortControl               = AUTO

ControlDirection          = Both

HostMode                  = MULTI_DOMAIN

ReAuthentication          = Disabled

QuietPeriod               = 60

ServerTimeout             = 30

SuppTimeout               = 30

ReAuthPeriod              = 3600 (Locally configured)

ReAuthMax                 = 2

MaxReq                    = 2

TxPeriod                  = 30

RateLimitPeriod           = 0

Dot1x Authenticator Client List

-------------------------------

Domain                    = DATA

Supplicant                = 0000.0000.ab01

        Auth SM State     = AUTHENTICATED

        Auth BEND SM Stat = IDLE

Port Status               = AUTHORIZED

Authentication Method     = Dot1x

Authorized By             = Authentication Server

Vlan Policy               = 12

Domain                    = VOICE

Supplicant                = 0060.b057.4687

        Auth SM State     = AUTHENTICATED

        Auth BEND SM Stat = IDLE

Port Status               = AUTHORIZED

Authentication Method     = Dot1x

Authorized By             = Authentication Server

Switch#

ll the above should be displayed, however this is missing from the customer device any help or advice?

thanks in advance

Lancellot