Mobility Express Setup Wizard

[kbenedict.spectrum]

Is there a way to avoid using the setup wizard on Mobility Express?  I can SSH into the controller and make configuration changes.  However, nothing will work until I the WLAN Express Setup flag is set to True.  

[Rasika Nayanajith]

Even CLI, you have to go through few config steps. Once you do that you are good with ME.

You referring something do via GUI ?

HTH

Rasika

[RFBarcode]

Hi there!

I have a similar issue where we have a remote controller which we can access via SSH but we can't connect to the auto provision SSID (to configure via browser) or via console cable (to configure via CLI).

Is there a way to run the same configuration wizard that is run over console, except via the SSH session? Or perhaps there is a script we could run to achieve the same result?

If anyone knows, it would really get us out of a bind!

Cheers