NCS Template Audit

[Si]

Hi,

Im currently migrating 2,400 APs to change controller addressing.
Id like to know is their a report on NCS i can run that will show me the AP config for Pri/Sec/Ter controller config

We are running  1.3 (1.3.0.20)

Ive had a look around but not found what i wanted, id like this information to know which templates need applying to which APs

many thanks

S

[Sandeep Choudhary]

Hi Si,

I never seen a template like this, may be someone else know or ever used this....

Why you want to change the ip of WLC at AP.

If you will change the IP of wlc at switch or ...other place (from where AP learn the ip address of WLC).

Just change the ip of wlc at that place, AP will learn automaticall if they are in correct vlan.

Regards

Dont forget to rate helpful posts

[Si]

Hi ,

Thanks for the response. Our ap's have had the wlc IP pushed via a template. I'd like to make sure all ap's have the same wlc as it's primary after the IP address change
just hoped their was some way of auditing this config

Sent from Cisco Technical Support iPhone App