New C9800 Different Regulatory Domain Access Point on same WLC

[ciscocco]

Question (we are currently in design phase of this project)

Client migrating from WLC 5508 (EoS) to new C9800-L-C-K9.  Client has geographic locations in US, Europe (Germany and UK) as well as Canada.  Most AP in US. 
Today all operating/registered to single 5508.  Is there a limitation in C9800 that will not allow the multiple domains to be configured/operate on  C9800? 
Can anyone shoot over link for how this is configured in C9800? 
Thank you in advance for the assistance....

[Sandeep Choudhary · Accepted solution]

Hi,

I think there is no limitation. you can configure multiple regulatory domain on WLc.

Generally, you configure one country code per controller, the one matching the physical location of the controller and its access points. However, you can configure more than one country code per Cisco WLC. Prior to Release 8.2, you could configure up to 20 country codes per Cisco WLC; from Release 8.2 onwards, you can configure up to 110 country codes per Cisco WLC.

Regards

Dont forget to rate helpful posts