no https/SSH access after testing failover in HA pair

[jworth123]

I cannot access the secondary controller, which is active after failing over while testing HA redundancy.

The weird thing is, as soon as I enable management over wireless, I can then management it over wifi while failed over to the secondary. But, as soon as I plug in to the wired network, I can't access the GUI at all.

These are 2 5508's with SSO enabled.

[ali aqrabawi]

what is the software version ?

is the mgmt interface pingable from the wired ? 

[jworth123]

8.0.121.0

yes, can ping from wired.

[jworth123]

This is resolved. I had the service port on the secondary controller configured for 192.168.1.1 which was part of the same vlan as the wired data network. I assumed it was not part of my customers wired data vlan. I configured the service port for another IP that was in an un-routed vlan. After I did this, I was able to https/SSH to the management IP while failed over to the secondary (secondary running as active).