cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
458
Views
5
Helpful
1
Replies

No puedo agregar mi Aironet 1815i a mi WLC 2500

KevinSibian5891
Level 1
Level 1

Ya configuro mi ap con direccion ip en capwap ap

y tambien configure capwap ap primary la ip del WLC con el nombre, pero en la wlc me aparece como "nojoin" nada mas, 

 

Ap Aironet con version cisco AIR-AP1815I-B-K9 AP Running Image : 8.3.111.0
Primary Boot Image : 8.3.111.0
Backup Boot Image : 0.0.0.0
1 Gigabit Ethernet interfaces
2 802.11 Radios
Radio FW version : 8edf74e05d634a962e683454e8fc1be2
NSS FW version : not available

 

Version de WLC: 7.6.130.0

 

Error de ap: 

CAPWAP State: Discovery
[*12/21/2020 19:10:54.0000] Discovery Request sent to 192.168.1.100, discovery type STATI C_CONFIG(1)
[*12/21/2020 19:11:24.0299] Discovery Request sent to 255.255.255.255, discovery type UNKNOWN(0)
[*12/21/2020 19:11:24.0299] Discarding msg CAPWAP_WTP_EVENT_REQUEST(type 9) in CAPWAP state: Discovery(2).
[*12/21/2020 19:11:24.0299] Discovery Response from 192.168.1.100
[*12/21/2020 19:10:54.0000]
[*12/21/2020 19:10:54.0000] This AP model is supported by controller version newer than 8.3.15.100!
[*12/21/2020 19:10:54.0000]
[*12/21/2020 19:10:54.0000] Discovery response from MWAR 'Etesal'running version 7.6.130.0 is rejected.
[*12/21/2020 19:10:54.0000] Failed to decode discovery response.
[*12/21/2020 19:10:54.0000] CAPWAP SM handler: Failed to process message type 2 state 2.
[*12/21/2020 19:10:54.0000] Failed to handle capwap control message from controller - status 4
[*12/21/2020 19:10:54.0000] Failed to process unencrypted capwap packet 0xa7f000 from 192.168.1.100
[*12/21/2020 19:10:54.0000] Failed to send capwap message 0 to the state machine. Packet already freed.
[*12/21/2020 19:10:54.0000] IPv4 wtpProcessPacketFromSocket returned 4
[*12/21/2020 19:10:54.0000] Discovery Response from 192.168.1.100
[*12/21/2020 19:11:24.0000]
[*12/21/2020 19:11:24.0000] This AP model is supported by controller version newer than 8.3.15.100!
[*12/21/2020 19:11:24.0000]
[*12/21/2020 19:11:24.0000] Discovery response from MWAR 'Etesal'running version 7.6.130.0 is rejected.
[*12/21/2020 19:11:24.0000] Failed to decode discovery response.
[*12/21/2020 19:11:24.0000] CAPWAP SM handler: Failed to process message type 2 state 2.
[*12/21/2020 19:11:24.0000] Failed to handle capwap control message from controller - status 4
[*12/21/2020 19:11:24.0000] Failed to process unencrypted capwap packet 0xa81000 from 192.168.1.100
[*12/21/2020 19:11:24.0000] Failed to send capwap message 0 to the state machine. Packet already freed.
[*12/21/2020 19:11:24.0000] IPv4 wtpProcessPacketFromSocket returned 4

 

 

1 Reply 1

Leo Laohoo
Hall of Fame
Hall of Fame

@KevinSibian5891 wrote:

Version de WLC: 7.6.130.0


WLC firmware needs to be upgraded to, a minimum, 8.3.112.0.

Review Cisco Networking for a $25 gift card