Noob Cisco Wireless Question

[ahleyjohn38]

I just set up a Cisco 5508 WLC and a 3702 AP. The AP is in flexconnect mode. Both the link to the WLC and AP are trunks. Both are using VLAN 255 as their managment ip. Facing the AP I used "switchport trunk native vlan 255", and am able to reach it over its management ip.

My question is, how do I set up an SSID to use VLAN 100 (or any other vlan)? When I go in to my AP, under the flexconnect tab, VLAN Mappings, it shows the wlan, but says its a "Centrally switched wlan". Its grayed out to specify which vlan it is in.

[Scott Fella]

You need to go to the WLAN SSID setting and enable "Local Switching".  That will give you the option under the FlexConnect section.

[Scott Fella]

Take a look at some guides and blogs on FlexConnect local switching.  That might help you understand what you need to modify in your configuration:

https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-1/Enterprise-Mobility-8-1-Design-Guide/Enterprise_Mobility_8-1_Deployment_Guide/ch7_HREA.html#pgfId-1103053

https://community.cisco.com/t5/wireless-mobility-documents/wireless-lan-flexconnect-configuration-example/ta-p/3112924