cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
515
Views
0
Helpful
3
Replies

Not able to configure the Access Point in standalone.

laukik.nahar1
Beginner
Beginner

Hi,

Have upgrade the IOS to ap3g2-k9w7-tar.153-3.JD

Please find the attached file for configuration done on Standalone AP.

I'm able to connect to Access Point using pre-shared key , but my Access point is not able to ping default-gateway , access switch or even DHCP server.

Need help for verification of the configuration and please share what more changes are required.

Also need to configure 3 Standalone AP's in mobility. It would be very helpful anyone can provide references.

Thanks

Laukik.

3 Replies 3

Kundan Prasad
Beginner
Beginner

remove these commands and then try pinging it..

ipv6 address dhcp
ipv6 address autoconfig
ipv6 enable

Hi Kundan,

Tried changing the above configuration , still not working.

Thanks,

L

i would suggest to reset the AP and start the config again from scratch.

Regards

Dont forget to rate helpful posts

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers