PEAP-GTC with WLC 2006

[a06246]

I am trying to configure a WLC2006 to use PEAP-GTC. The ACS server is currently setup and works find with our autonomous AP's.

In the ACS failed attempts log, I see entries with "PEAP-0012xx4544" as the username instead of the username I enter into the PEAP client on my laptop. I'm using the exact same PEAP client and config on my laptop for both the autonomous and lightweight AP's and I only have this issue with the LAP's. Can someone point me in the right direction?

Thanks!

[segopala]

hi ,

have you confiured WLC 2006 ip in the radius server ?

can you get me

debug aaa events enable

debug dot1x events enable - output from the controller

which supplicant are you using ?

what does the RSA logs say ?

please get me the following info

We dont use any sp config for PEAP - GTC ; this should work as any dot1x authentication ... debugs will give more info

regards

Seema

[a06246]

There was actually an internal Cisco doc that described the fix for this. There were a few timers and such that needed to be changed. I had everything setup correctly and once I changed the timers all was well.

[segopala]

Hi,

Try removing PEAP-001279BF4544 from the secuirty - configuration - advanced the default comes as

PEAP-001279BF4544 - replace it with login name ;

i tried GTC on 2006 so it wrks let m eif you stuck

regards

Seema