Wireless

I'm trying to figure out if it is possible to feed this accesspoint with the Cisco Pre-standard Inline Power from a 3524-PWR switch.When I turn on the Accesspoint it shows that there is not enough inline power available to turn the radio's on. Accord...

Hello,I have to manage a wlc 4404. According to me he acts strange.Only ports 1,2 and 3 are connected. The ap-manager and the management are linked at port 1. So far so good.If I look at the wireless-tab I see all AP's are connected at port 3 !! All ...

Dear all,I want to configure a 876W router to have a public wireless LAN with internet access only and a wired LAN (different IP network) with an IPsec VPN connected to the companys network.I want to seperate the two networks putting them into two di...

Has anyone had any client compatability issues when mixing 1242 and 1231 AP's within the same site? My older Symbol clients are freezing up etc when roaming to the 1242's while new clients are fine roaming within both flavors of AP's. The configs are...

Dear Sir,Please guide me how I can expand up my Signals ?I am receiving signals from my upstair room I need to be expand these via an antenna or any thing ,Please guide me how I can be.http://cancee.com/vpn/Signals.JPG Regards,Hammad

I have a 4402 WLC to act as an anchor controller in a DMZ enviroment.My wireless clients associate with several WiSM's in the local network.I would like to create a WLAN that uses 802.1x (WPA2) to authenticate the clients and then bind them to the an...

Hi, I have an issue with the access point. It has SSIDs one is secure and other is the guest account. But, for some reason the guest account is not working. Can any one help?

When I configure multiple ssids they seem to work fine until I add any sort of security.When a add a simple WEP key my data vlan works fine, I can get to all the interfaces and networks, but my voice vlan does not it does get an IP from the dhcp serv...

Hi there,I am a little challenged to configure WPA2 with PSK on a c871W. I searched through Ciscos documentation but only found topics about WPA. So could you please advice me how to activate WPA2 (w/AES) on a 871W box?Thank you....Andy

We are running the LWAPP (2006 wlc's and 1242 AP's) and using the ACS 4.0 for authentication. Our users areexperiencing an issue, where they are successfully authenticated the first time, however as the number of them is increasing, they're starting ...

I have a cisco access point ( model : AIR-LAP-1242AG-T-K9). I want to know how can I access it through GUI. The IOS version is 12.3(7)JX . Is this version OK. What is the difference between LWAPP & Autonomous mode. What may b d IP adress of the acces...