Hello Forum Members!
I have such a funny problem with my Wireless components! I Have 3 Aironet 1130 an 1 WLSE in my network. I configured the 3 Access Points (IP, SNMP, CDP) an connected them to my Catalyst 6500. At the WLSE I just made the basic setup configuration with ip, gw,... and after I connected the WLSE also with my Catalyst.
So the funny part starts here! To configure and to manage the AP's I need a connection to the AP's from my WLSE. So I saw that i can ping every component in my network from my WLSE, except the AP's. And I can ping from the AP's every component in my network, except the WLSE.
They can not communicate with each other. Then, after 100 times trying out, I just get a connection. I can ping eachother, but after few minutes its over. The connection is down??
Where is the failure/problem? I thougt that it is the catalyst but i'm not sure... On the port of the catalyst (where the wireless components are connected) i just disabled 802.1x and on the wireless ports i turned on trunking, because of my vlan situation.
has anybode an idea?
Bulut
