Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1333
Views
27
Helpful
16
Replies

Prevent Access Points from authenticating with my WLC?

abrrymnvette
Level 1
Level 1

‎11-07-2013 11:03 AM - edited ‎07-04-2021 01:14 AM

I have a WLC 2112 and currently if you plug in a Cisco access point, it will connect to the controller and download the config. I don't like this and want to allow only the AP's that I specify. Anyone could just walk into one of our buildings and plug in an AP and get our entire wireless config. Is there a way in the WLC 2112 to only allow the AP's that I specify to be connected to the controller?            

Labels:
0 Helpful
16 Replies 16

Florin Barhala
Level 6
Level 6
In response to Leo Laohoo

‎11-13-2013 09:48 AM

Thanks guys, just wanted to be sure as I am fairly new to this "wireless-chapter".

Other than automatic exclusion from default-group are there any other consequencese when using a WLAN ID equal or above 17?

0 Helpful

Leo Laohoo
Hall of Fame
Hall of Fame
In response to Florin Barhala

‎11-13-2013 01:16 PM 

Other than automatic exclusion from default-group are there any other consequencese when using a WLAN ID equal or above 17?

Not that I can think of.

Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card