Problem with Cisco AP 1142N-K9 configuration

[Legust321]

How can I have access to the cisco "AP#" prompt?

When I try to acees the AP through hyperterminal, it gives me the attached messages. The message keeps looping and not letting me access the AP# command prompt to assign an IP address so that I can control it in mode HTTP.

I will really appreciate if I can have assistance with that.

Joseph.

[Scott Fella]

You have a lightweight AP which requires a WLC. If you need a stand alone autonomous ap, then you need to convert that ap to autonomous. You can search the forum for:

LWAPP to Autonomous

Thanks,

Scott Fella

Sent from my iPhone

[Scott Fella]

Here is a link;

http://www.cisco.com/en/US/docs/wireless/access_point/conversion/lwapp/upgrade/guide/lwapnote.html#wp160918