cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
792
Views
9
Helpful
6
Replies

Pulling controller config from NCS

thefranmanatt
Level 1
Level 1

So it looks like by default NCS doesn't back up the Controller configs to the tftp folder.  Is there anyway to get the config from the NCS?  Clearly it has to know the controller's config for audits. 

Replacing a dead controller with a new blank controller is turing in to a nightmare.  Putting a base config so the NCS can talk to the new WLC and then doing an audit with update controller with NCS settings is coming back with a ton of errors.

CCNP - Wireless
CWNE #136
6 Replies 6

Scott Fella
Hall of Fame
Hall of Fame

You can schedule a task to backup the WLC configuration. Pushing out templates is not a good idea for a restore at all. Having the latest good config is the way to go.

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***

I hate NCS....

CCNP - Wireless
CWNE #136

HI Scott Fella,

Can you please tell me how to schedule a backup for the Controller in NCS

Here is a link:

http://www.cisco.com/en/US/docs/wireless/ncs/1.1/configuration/guide/admin.html#wp1356324

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

-Scott
*** Please rate helpful posts ***

Hey Thanx allot Scott Fella....

Abhishek Abhishek
Cisco Employee
Cisco Employee

Hello ,

As per your query i can suggest you the following solution-

Choose Administration > Background Tasks, then click Controller Configuration Backup to access this page.

This page enables you to view the history and current status of Cisco WLAN Solution configuration backups.

From the Administration > Background Tasks page, you can execute, enable, or disable this task. To execute, enable, or disable this task from the Administration > Background Tasks page, follow these steps:


Step 1 Choose Administration > Background Tasks.

Step 2 Select the check box(es) of the Background Task(s) that you want to execute, enable, or disable.

Step 3 Use the Select a command drop-down list to perform one of the following tasks:

• Execute the task now—Select the check box of the task you want to execute. From the Select a command drop-down list, choose Execute Now, and click Go. The status changes in the Enabled column.

or

• Enable the task—Select the check box of the task you want to enable. From the Select a command drop-down list, choose Enable Task, and click Go.

or

• Disable the task—Select the check box of the task you want to disable. From the Select a command drop-down list, choose Disable Task, and click Go.

Hope this will help you.

Review Cisco Networking for a $25 gift card