09-17-2001 12:04 PM - edited 07-05-2021 12:02 PM
We are having a tough time coming up with a "good" Win98 client package. Does anybody care to share what level:
1) NIC firmware
2) Drivers
3) ACU s/w
they used to successfully install on their Win98 based laptops while enabling LEAP?
TIA,
Dave...
09-20-2001 11:41 AM
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
Thank you for posting.
09-21-2001 07:44 AM
Here is what seems to work well for me in testing, we haven't deployed this on a wide scale yet.
If I run ACU->Commands->Status here are my settings on my Win98 client (350 card)
Firmware Version = V4.13
Bootblock Version = V1.50
NDIS Driver Version = V6.97
I'm running ACU 4.15.006 , our 350 AP is running 11.07
Hope this helps
Kent E.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide