Radius assigned IP addresses to clients

[firestartest]

Has anyone got ACS to pass on IP addresses to wireless clients when they authenticate? Is there a specific attribute to configure?

[smalkeric]

I do not think this is possible since the APs are basically hubs which work on Mac addresses.

[dixho]

I am not sure if it helps. The closest you can get is VLAN assigned by radius server. The URL is as follows:

http://www.cisco.com/en/US/products/hw/wireless/ps4570/products_configuration_guide_chapter09186a0080184ace.html#1038739

In general, 802.1x (i.e. the protocol for wireless authentication) is EAP over LAN. This is authentication process for layer 2 devices.