Wireless

HiI just updated two 1130AG to the latest IOS (12.4.x).Now I always have disconnects several times in minute. One 1130ag is the root ap, the other is configured as workgroup-bridge.On the workgroup-bridge the radion interface didn't come up, it is in...

We are currently testing AP1242 (used as Workgroup bridge) to replace our current client bridge device that uses PEAPv0 as authentication protocol. The assumption was that AP1242 (as WGB) supports PEAP (v0 or v1). But the ACS server failure log is te...

I can to have two SSIDs for all branch of my country, but each ones in a differents subnets,for example:Area 1SSID 1 : guest -> 192.168.1.1SSID 2 : office -> 192.168.2.1Area 2SSID 1 : guest -> 192.168.3.1SSID 2 : office -> 192.168.4.1I have configure...

Hi,I was trying to upgrade Cisco 4402 Wireless LAN Controller from 4.0.171.0 to 4.0.206.0. I was able to upgrade one of WLC without any issues.When i tried to upgrade another WLC, i was getting an error " Failure with Signature Verification".Can any ...

Hi NetPro,currently i am using tacas, and i want to create a new user account but limited right. example: this user only can use " show Command " in my Cisco switch.how do i make it ?your reply will be highly appreciated.regards,Jackal

Hi Everyone!I have the following doubt:Is the 1242 able to support point-to-multipoint? I haven't found information regarding this particular feature, tell me if you have already configured a point-multipoint 1242Thnks

Other than the multi channel of the 1042 access point, what is the significant difference between the two?We usually install only one at each location 20,000 sq. ft. is open warehouse15 ft. ceiling?

L.s.Why is there a undeletable Mesh template on my controllers?since upgrade to latest version of WCS and controller-SW (3750+wlc) (wism) i have on 2 of my controllers a mesh tmpl.when i try to remove wcs tells me that's not possible.tried to do it d...

We have Cisco 1200 APs with IOS 12.x running. Still need to confirm IOS version. Has anyone come across any problems with Vista running Internet Explorer 7.0 browsing the internet ?User is currently getting page not found when he tries to access the ...

Hello,I have a weird problem. I converted a AP1240 to LAP (k9w8.tar). Now they dont connect to the WLCs. I sniffered the traffic to find some clue. the following happens:1. LAP sends LWAPP-disovery to the IP-Adresses of our 3 WLCs and a broadcast. (1...

Hi, folks,I am trying 1200 WPA/802.1x(EAP). But now run into issues. It's a little strange. Everything I restarted ACS service, the authentication can pass, but after that when I disable or repair the wireless and try again the authentication fail.12...

I have a wcs and found how to do rogue AP location tracking, but i haven't figured out if it is possible to show the location of a legitimate client connected on the network, without having a Cisco Location Appliance.Is this possible?

Hi guys, I hope someone could help me with this:We are using a 4402 Controller and have a WLAN with EAP authentication. That's working just fine. But now we are trying to add a Guest WLAN with WEB authentication. And that also works fine. The thing i...