cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
158
Views
0
Helpful
0
Replies

Rate limit for different deployment scenarios

artem.ivanov
Beginner
Beginner

Good afternoon!

I'm new in Cisco and looking for information about bandwidth rate limiting ways for different deployment scenarios.

As I found, it's not possible to tune rate limiting for 2504 hardware controller. What is default behaviour in this case? Is there any priority wlan configuration exists? e.g. wlan1 - high-priority voice, wlan2-employees normal priority with rate limit and wlan3 - guests best effort with rate limit.

Also I wonder how does it work for Mobility Express, FlexConnect and vWLAN central controllers? If it equal % or mbps or air time for all clients? Is there any settings to change it?

Could not find it in conf guides.

Thanks a lot!

0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers