Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
252
Views
2
Helpful
2
Replies

re-authentication during use after upgrade to 17.15.0.3

id404
Spotlight
Spotlight

‎06-19-2025 07:06 PM

Since upgrading my Cisco C9800-40 Wireless Controller to 17.15.0.3, the wireless guest authentication will ask for re-authentication during use, which is very disruptive to the user. Also the wireless guest authentication is using CWA method to interface with Cisco's ISE. is there any way to troubleshoot this issue.

0 Helpful
2 Replies 2

marce1000
Hall of Fame
Hall of Fame

‎06-19-2025 10:32 PM

 

                 - FYI : https://logadvisor.cisco.com/logadvisor/wireless/9800/9800CWA

  M.



-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

Scott Fella
Hall of Fame
Hall of Fame

‎06-20-2025 07:22 AM

Did you at least run a diff using the previous configuration file vs the configuration after the upgrade?  If you have problems after the upgrade, you should revert back. I see soo many folks that just make a change, cause some sort of outage and then try to remediate the issue causing user experience issues.  

-Scott
*** Please rate helpful posts ***
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card