About id404

id404 · 09-20-2023

能否设置一个固定的账号，只能运行以下show命令，该账号无法进行配置，无法运行其它show命令? show versionshow running-config show running-config allshow ip interface

id404 · 09-17-2023

刚部署了两台N9K-C93180YC-FX3和三台N9K-C93108TC-FX3P，其中三台N9K-C93108TC-FX3P设置为FEX Dual-home模式分别连接到两台N9K-C93180YC-FX3. 目前发现一旦在接口下配置过speed 100 、speed 1000、speed 10000后无法将接口设置回speed auto。就算将接口的配置no掉或default interface XXX后，在show run 都会显示speed XXX 请问有什么方式可以将接口设置回spe...

id404 · 09-17-2023

Hi everyone We just deployed two N9K-C93180YC-FX3 and three N9K-C93108TC-FX3P. C93108TC-FX3P using FEX mode, dual-home connected to two N9K-C93180YC-FX3. By default the N9K-C93108TC-FX3P are interfaces are all in duplex mode with rate auto-negotiatio...

id404 · 09-08-2023

I am planning to upgrade my C93180YC-FX3 switch from version 9.3.8 to 10.3.3. but during the upgrade process I get the message "Return code 0x40450037 (Not a valid nxos image)". I have confirmed that the nxos64-cs.10.3.3.F.bin file md5 is correct. At...

id404 · 09-01-2023

In this web page https://www.cisco.com/c/dam/en/us/td/docs/Website/datacenter/fexmatrix/fexmatrix.html, we found that N9K-C93108TC-FX3P is supported as N9K-C93180YC-FX3 line card. Is there any configuration information about it? I only found Nexus ...

id404 · 12-13-2022

AP501C.B024.06D0>show versionRestricted Rights Legend Use, duplication, or disclosure by the Government is subject torestrictions as set forth in subparagraph (c) of the CommercialComputer Software - Restricted Rights clause at FAR sec. 52.227-19 and...

id404 · 06-28-2022

How can i access the standby using CLI ?

id404 · 06-14-2022

我搜索到相关链接了https://www.cisco.com/c/en/us/support/docs/wireless/catalyst-9800-series-wireless-controllers/217050-convert-installation-mode-between-instal.html

id404 · 06-14-2022

目前是bundle模式HA sso的话，能否通过install add file bootflash:xxx.bin 命令将双要同时转换为install 模式?

id404 · 06-14-2022

我手头上的9800 Installation mode 是 BUNDLE 也是就通过配置命令boot system flash bootflash:C9800-L-universalk9_wlc.17.03.03.SPA.bin 假如新的IOS上传至9800 active 机上，是否只需要配置boot system flash bootflash:C9800-L-universalk9_wlc.17.06.03.SPA.bin

Member Since	‎11-13-2015 05:46 AM
Date Last Visited	‎09-21-2023 11:59 PM
Posts	49
Total Helpful Votes Received	21

User Statistics

User Activity

能否设置某个账号只能运行部分show 命令?

N9K-C93108TC-FX3P 无法将接口设置回speed auto

N9K-C93108TC-FX3P Interface cannot be restored back to speed auto

C93180YC-FX3 upgrade failed

How to Configure the N9K-C93108TC-FX3P Switch as a FEX extend Switch ?

Re: 1852E Mobility Express AP can not join ifself

Re: How can I restart the host or standby machine in 9800 SSO mode

回复：两台9800 sso部署，如何将ios镜像复制至备机

回复：两台9800 sso部署，如何将ios镜像复制至备机

回复：两台9800 sso部署，如何将ios镜像复制至备机