Set Hours of Operation on 1602

[jshircel]

On a stand-alone SAP 1602I-A-K9 access point, is it possible to only allow people to connect to the access point during certain hours of a day?  For example: 8:00 am - 7:00 pm?  If so, where is that setting located?                   

[Scott Fella]

There is nothing you can do on the AP. On the switch you can create a time based ACL to prevent traffic.

Sent from Cisco Technical Support iPhone App

[Leo Laohoo]

I agree with Scott.  Filters Using Time-Based ACLs

[Ravi Singh]

You can implement time based ACL on AP or Switch for filtering the traffic. For configuring the same please go the below link.

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a008058ed26.shtml