Setting the location in 5760

[Teamitlead]

I am trying to find a way to set the "location" information in the WAPs that are connected to the 5760. When I try to make the changes manually via the web interface, the changes don't stick. I have not found out how to make the changes via CLI. Any assistance in figuring this out would be greatly appreciated. 

[Saurav Lodh]

CCX Location Measurement Q – Default is off; enable if you use the CCX location features:

ap dot11 24/5ghz rrm ccx location-measurement <cr>

Use the no form to disable.

Refer

http://www.cisco.com/c/en/us/td/docs/wireless/technology/5760_deploy/CT5760_Controller_Deployment_Guide/Radio_Resource_Management_Configuration.html

[Teamitlead]

I tried the steps outlined, but run into an issue at the ccx line. When I type that into the 5760, it gives me an error message stating unrecognized command. The options given for after the rrm are:

channel-update

dca

grouping

txpower