SNMPv3 Support

[ranjeet90]

Hi All,

Please help with below Access points if they support SNMPv3 and if not, do they at least they support snmpv2 or v1.

Cisco AIR-CAP3502E-E-K9
AIR-LAP1262N-A-K9

Thanks in advance.

[balaji.bandi]

is this register with WLC or what mode AP running ? what code it running ?

based on the code running it support if this is latest version.

[ranjeet90]

Hi Balaji,

Please find below details for both AP models.

Pri Software version- 8.2.166.0
IOS version - 15.3(3)JC14$
AP Mode running- Flexconnect mode

[Ambuj M]

This code does support SNMPv3,2c and 1.

v3 obviously being recommended. 

[Scott Fella]

@balaji.bandi is right... but if I look at your model number, the CAP requires a controller, unless it has an autonomous image for stand-alone and the LAP is a standalone.  Either way, it depends on the code you are running, if its old, I doubt it supports v3, but v1 and v2, should be supported.

[ranjeet90]

Hi Scott,

Yes APs are connecting to Cisco 5500 series WLC.

[balaji.bandi]

we have 5508 running 8.0 code can support SNMPv3