03-15-2017 11:46 PM - edited 07-05-2021 06:42 AM
Can anyone inform me how to find the exact number of software defined network SDN controllers to be implemented in wireless sensor network environment.
p.s These controllers will be connected via Ethernet cable.
Solved! Go to Solution.
03-20-2017 12:06 PM
Your talking about APIC-EM. In that case, for high availability, you need 3 nodes.
For high availability and scale, your multi-host deployment must contain three hosts.
03-20-2017 12:12 PM
I haven't seen any documents about size of network versus number of controllers. I imagine it will depend a lot on what the network is going (for example, iWAN or something else).
If it was me I would probably go for three nodes, like in the deployment guide. This is likely to be a well tested scenario by Cisco. Then if it was having trouble coping, beef up the hardware with more RAM and CPUs.
I just found these APIC-EM appliances you can buy, all ready to go:
It gives these specs for a "large Network"; 2 physical CPUs; 128B of RAM; 3.4TB of disk and 2 Gigabit NICs. You would have to think that three of these would be a well tested scenario.
03-16-2017 08:36 PM
There is not even slightly enough information to start answering your question.
03-20-2017 02:37 AM
Im going to use sdn controller in wsn, where sensors are randomly deployed and their number ranges from 500 to 1500 sensors in a given field size. The question is how to determine the exact number of sdn controllers for such network? Some say that it should be odd number ( not one for reliability reasons) so at least three controllers , but Im not sure if it is applicable to any network size....
still confused
03-20-2017 12:06 PM
Your talking about APIC-EM. In that case, for high availability, you need 3 nodes.
For high availability and scale, your multi-host deployment must contain three hosts.
03-20-2017 11:47 PM
Thank you Philip
03-20-2017 12:12 PM
I haven't seen any documents about size of network versus number of controllers. I imagine it will depend a lot on what the network is going (for example, iWAN or something else).
If it was me I would probably go for three nodes, like in the deployment guide. This is likely to be a well tested scenario by Cisco. Then if it was having trouble coping, beef up the hardware with more RAM and CPUs.
I just found these APIC-EM appliances you can buy, all ready to go:
It gives these specs for a "large Network"; 2 physical CPUs; 128B of RAM; 3.4TB of disk and 2 Gigabit NICs. You would have to think that three of these would be a well tested scenario.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide