Static IP address for Guest Wired network

[#1]

I setup a guest wired network on the WLC 5508 with 7.2.110.  A postage machine can only be setup for static IP address over guest wired network.  Is any one how to get it configure on the WLC 5508?

Thanks,

[Stephen Rodriguez]

So, you configured a 'wired guest' network, and need to assign a static IP to the device?

You should be able to assign an address from the egress interface range, as up to the WLC it's just a L2 link

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

[#3]

Steve,

A client device need a static IP address within the DHCP range from the WLC.  Is it possible to assign a static IP addresses within DHCP range on the WLC.

Thanks,

Eric

[Stephen Rodriguez]

Yes and no. Yes you can use the same subnet, but you would need to exclude the static address so that it can't be given out.

Steve

Sent from Cisco Technical Support iPhone App