SW C9200L-48P-4G

[Ivannoty]

Hi every one! I have this kind of issue, I connected a cable in Cat 2960-CX (trunk)  and other side SW C9200L-48P-4G this SW we ready connect 9 access point C9115AXI over POE, one time connected, automatic restart this only C9115AXI' ports...i been cheeking the configuration and has set power inline in auto both SW..

I really appreciate your comments !!!

Port in C9200L-48P-4G

interface GigabitEthernet2/0/19
description COM-SWH-UP-MXVZBPBIMSUS05-Gi0/9
switchport trunk native vlan 999
switchport trunk allowed vlan 15,45,100,124,162,164,202,204,303,334
switchport mode trunk
switchport nonegotiate
spanning-tree portfast disable
spanning-tree bpduguard disable

Version IOS 17.4.1,

Port in Cat 2960-CX

description COM-SWH-UP-MXVZNEABPBs01-G1/0/48
switchport trunk allowed vlan 15,45,100,124,162,202,204,303,334
switchport trunk native vlan 999
switchport mode trunk
switchport nonegotiate
spanning-tree portfast disable
spanning-tree bpduguard disable

Version IOS 15.2(4)E2,

[MHM Cisco World]

VLAN 164 is not allow in trunk ? allow it and check stability again.

[marce1000]

       >...one time connected, automatic restart this only C9115AXI' ports

                        Do you mean ports or access points ?

 M.

[Ivannoty]

Hi @marce1000. I mean the access point, an then after 3 minutes around reconnect OK with  the WLC9800 series...

[Ivannoty]

Hi every one, probably couldn't explain good but i found this bug in 9200L PD

I will check in time when not disturber user connection 

BUG: CSCvy62881

https://bst.cloudapps.cisco.com/bugsearch/bug/CSCvy62881