- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-06-2016 07:14 AM - edited 07-05-2021 04:52 AM
Hello.
I got a Doubt about the Switch Port in my Cisco Switch to a Appliance of Prime Infrastructure.
This port needs to be a Switchport access or a Switchport Trunk?
Which is your Recommendation about this? What is the best Practices?
Thanks a lot.
Solved! Go to Solution.
- Labels:
-
Wireless Network Management
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-06-2016 07:43 AM
Access Port should work fine. You do not configure a VLAN on the appliance itself, just the IP address / subnet and default gateway.
Thanks,
Ric
Please rate helpful / correct posts
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-06-2016 07:43 AM
Access Port should work fine. You do not configure a VLAN on the appliance itself, just the IP address / subnet and default gateway.
Thanks,
Ric
Please rate helpful / correct posts