cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
552
Views
0
Helpful
3
Replies

Troubles upgrading AP from IOS to LWAPP

edgar.valdivia
Level 1
Level 1

Hello Everybody...

I`m trying to upgrade my AP running IOS version 12.3(8)JA2 to lightweight version 12.3(11)JX1 using Upgrade Tool 2.01. I get the error "unable to Load the LWAPP Recovery Image on to the AP".

I`ve already upgrade my WLAN Controller from version 3.2 to 4.0179.8.

Could some one help me with this issue?

Upgrade Tool log is attached here.

Thanks in advance

1 Accepted Solution

Accepted Solutions

jakew
Level 1
Level 1

Check your TFTP server is properly configured. If you're using the Upgrade Tool embedded TFTP server, a common culprit is personal firewall software, which will block incoming TFTP.

View solution in original post

3 Replies 3

zhenningx
Level 4
Level 4

Looks like AP can not successfully transfer the recovery LWAPP image from your TFTP server. Check if the tftp works from your tftp server to the AP.

jakew
Level 1
Level 1

Check your TFTP server is properly configured. If you're using the Upgrade Tool embedded TFTP server, a common culprit is personal firewall software, which will block incoming TFTP.

k.links
Level 1
Level 1

the upgrade tool cannot deal with AP names with special characters. try changing the AP name to something simple and run it again.

Review Cisco Networking for a $25 gift card