03-15-2019 03:00 AM - edited 07-05-2021 10:03 AM
Hello,
I'm implementing trustsec on my wireless network.
I am getting the setup to work on 3800 AP's. The client is tagged with the correct SGT tags, and the trafick is permitted/denied as intended.
However, on the same controller, with the same clients, when I connect the clients to a 3700 AP, I don't get the segemtation to work.
I can see on both the WLC and the AP, that the clients is getting the correct SGT tag, but it still hits the default Permit_All ACL.
So, to sumarize:
8540 with 3800 AP works like a charm.
8540 with 3700 AP doesn't seem to work.
AP's are in local mode, not flex connect.
SW version on the WLC: 8.5.135.0. (Have also tested with upgrading to 8.5.140.0, and 8.7.106.0, still same problem)
Has anyone else experienced this issue?
Regards
Odd K.
03-15-2019 05:35 PM
I'm going to suggest that its a bug. Have you logged a support ticket?
APs in the same AP group?
Take a look at this bug sounds very similar:
https://bst.cloudapps.cisco.com/bugsearch/bug/CSCvg62508
03-18-2019 04:49 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide