Two bridges communicate near on of each other but not on real link

[mauricioharley]

Dear friends,

I'm configuring a link between two 1310, one using a Yagi and the other using a omni. The configuration is pretty simple, without any type of special feature, like cryptography. When the bridges are near one of each other, the link is perfect, but it does not run when I put them on the real situation.

The same like runs ok when I use 350 bridges. What can be happenning? I did not change the antennas.

Thanks,

Mauricio

[ebreniz]

Check out your using the right type of cables and Antennas.

http://www.cisco.com/en/US/products/ps5861/products_data_sheet09186a008022b11b.html

http://www.cisco.com/en/US/products/hw/wireless/ps458/products_data_sheet09186a008008883b.html