Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

We have multiple 4404 controllers in the same mobility group. Because our controllers are placed into different buildings and our common SSID is set on WLANs on different VLANs/subnets, I would like to ensure "inter-subnet roaming" occurs in case a c...

I recently installed a 4400 for a customer, everything works fine except that the access points randomly disconnect from the controller, reboots and connects again. (5-10 minutes between reboots)Any suggestions on why this is happening?(i was on cons...

dhusand by • Community Member
  • 2509 Views
  • 6 replies
  • 0 Helpful votes

I have installed a Controller 4402 with version 4.0.217.0, APs 1010, with server of authentication RADIUS of Microsoft (IAS), using 802.1x with PEAP and MS-CHAP-v2. I have a problem in the first authentication, it is not only that he is slow, is that...

slandeira by • Level 3
  • 957 Views
  • 3 replies
  • 0 Helpful votes

I have a Cisco 3750 switch with the following VLAN's2 - Engineers3 - Automation Dept4 - AN Other Company5 - Guest AccessI have an 1131ag connected to the 3750 and I have setup a dot1q trunk on the swithchport that connects to the AP.http://www.cisco....

davehedgehog by • Community Member
  • 1140 Views
  • 3 replies
  • 0 Helpful votes

Does anyone know how to protect your WLC from Multicast/Broadcast storms coming for LWAPPs? I have enabled "config network multicast global disable" on WLC cli but this only protects you from wired storms. I have upgraded the OS to 4.1.181.0 didn't w...

rtford31 by • Community Member
  • 3717 Views
  • 10 replies
  • 0 Helpful votes

I'm trying to load the new WLC software. It's 36+ meg. The WLC only allows TFTP transfers. The file is to large for TFTP. Please don;t tell me the only way to load this file is XMODEM???

jphilope by • Level 5
  • 936 Views
  • 3 replies
  • 0 Helpful votes

Well basically my situation is as follows: we are using 40 Cisco AIR-AP1242 around 3 building sites for our school ( Ramsey Grammar ) which all are secure WEP and working fine however we would like to have two locations open and Virtual LAN direct to...

rgs.sch.im by • Community Member
  • 1161 Views
  • 2 replies
  • 0 Helpful votes

It took me some time and many tftp transfers to finally find an IOS that works fine with the HWIC-AP (wireless access point module) for a 2801 router.What I am wondering: Is there an IOS that supports both the HWIC-AP and also includes Call Manager E...

marc.lehner by • Community Member
  • 685 Views
  • 1 replies
  • 0 Helpful votes

I have both interfaces setup as lag, connected on different switch cards on the same switch.In the switch logs, it is returning errors that the host is flapping. Is there something I have configured incorrectly, or is that expected behavior due to th...

jarrodpicha by • Community Member
  • 968 Views
  • 3 replies
  • 0 Helpful votes

I work in an office where the wireless routers are so close together that now, while I am trying to document each router and their MAC addresses I cannot differentiate which is which. I was wondering if there is a way to hardwire into each router and...

NormedJakeH by • Community Member
  • 565 Views
  • 1 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card