Unable to Access GUI of Mobility Express

[hluislopez]

Here is the run down.  Purchased an 1850i with CAPWAP.  Converted to ME with AIR-AP1850-K9-8-5-103-0.tar.  Configured ME as stated in the guide.  After configuration, I cannot access the ME GUI.  I can connect to SSID and access the internet fine.  When I access the GUI, it shows a page labeled as OfficeExtend Access Point.  My password that I created in the initial setup, Cisco/Cisco, etc. do not work.  Based on the guide, I should see Wirelss LAN Controller instead.  Any help would be appreciated as I want to be able to do minor changes to the AP after I mount it on the ceiling and do not want to have to console in.

Thanks in advance.

[Flavio Miranda]

Hi,

 When your AP came up did you see the SSID CiscoAirProvison then you connected to it and which IP did you received ?

[hluislopez]

I have the device configured and ip is 192.168.64.2. When I go to http://192.168.64.2, it comes up with the screenshot I attached.

[Flavio Miranda]

there´s no attached file but it is ok. What I asked is if you got an IP address from the AP DHCP when you connected on the default SSID.

 usually this SSID  provide an IP address on the 192.168.1.X and you can connect to the web interface using 192.168.1.1. 

 This is the default behavior.