cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
443
Views
0
Helpful
1
Replies

Uploading configuration file issue

admin_2
Level 3
Level 3

Hey everyone,

I hae a 1200 Series Aironet Cisco WAP. I'm new to the organization and I have to upload the configuration file for the WAP to it. I have the configuration file all done. In order to Telnet to the WAP, do I plug a console cable in and whatnot?

Also, is there documentation on any type of uploading for config files?

Thanks

-Matt

newman@yavin4.com

1 Reply 1

Scott Fella
Hall of Fame
Hall of Fame

Use your rollover cable to connect to your AP directly and make sure your settings are correct. In order to telnet to the AP you have to have an Ethernet connection to the AP and have a valid IP address on the AP. To load you config file you can do it through your gui or paste it from the CLI.

http://www.cisco.com/warp/public/779/smbiz/prodconfig/help/eag/ivory/1100/h_ap_system-sw_sysconfig.htm

-Scott
*** Please rate helpful posts ***
Review Cisco Networking for a $25 gift card