cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
5107
Views
0
Helpful
4
Replies

vWLC and Default terminal

Darren Lynn
Cisco Employee
Cisco Employee

Hi All,

playing with the vWLC, does anyone know how to set the Default Terminal?

I have this habit of switching screens when things reboot, and once the "press any key to make this the default terminal" option times out, i have to reboot the vWLC again.

Wondering if anyone has fixed it, or know where the default terminal is?

Is it the Service Port? or the Serial Port?

Cheers

Darren                  

4 Replies 4

Scott Fella
Hall of Fame
Hall of Fame

I really don't know what you mean by default terminal. I always either open a console from VM or just ssh into the management io of the vWLC.

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***

This hasnt been forgotten about.

the Lab went boom in a power issue so is in the process of being restored.

daviwatk
Level 3
Level 3

From vWLC Config Guide http://www.cisco.com/en/US/products/ps12723/products_tech_note09186a0080bd2d04.shtml

Console port setup for (5.1ESXi example): http://www.cisco.com/en/US/products/ps12723/products_tech_note09186a0080bd2d04.shtml#port

This will default your console to the specified telnet://: as described in the example.

Also

Note:

Only one mode of console can be operational at any time, such as a VM console (by key-interrupt at startup) or serial console (physical/network). It is not possible to maintain both at the same time.

Otherwise; if you don't catch the "press any key" screen, you're stuck without console access until you reboot and try again.

Thanks David,

When the LAB is reinstated, Ill take another attempt at it.

I fit the typical engineer, act first, read later..

Cheers

Darren

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: