I have a WAP121 Access Point that continues to work perfectly since installation in early 2014. I am unable to access the setup/configuration. I have the correct IP address for the AP as shown on the router's IP list but when trying to access the AP at that address I receive the message "192.168.1XX.XXX refused to connect" in my browser. Any suggestions for how to connect to this AP's setup/configuration?
Problem solved by matching MAC address of AP to those listed on the IP list of the router and noting my use of incorrect IP. Can now access AP setup/configuration of AP.
Old lessons relearned. Thank-you for a goof first experience here.
-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? ' When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '
Problem solved by matching MAC address of AP to those listed on the IP list of the router and noting my use of incorrect IP. Can now access AP setup/configuration of AP.
Old lessons relearned. Thank-you for a goof first experience here.
